So, I wanted my character to switch to zone 2, but it says it has a script error
@follow YOU to spot 0.68 122 267 in zone 2
That was the command I used. Is there any problems?
Jadlyss
September 24, 2018, 11:06pm
2
The scale in a spot formula usually is four digits, 0.68 is only 3
JemU776
September 24, 2018, 11:08pm
4
Read this:
Following a character to a different zone:
The follow command:@follow CHARACTER to POSITION in zone # and CHARACTER does it while animation
An example using this command:@follow CHARACTER to screen center in zone 2 AND CHARACTER does it while run_jog
The follow command using spot directing:
&pan to zone # in T @CHARACTER walks to spot S X Y in zone # in T and CHARACTER does it while animation
An example for it:&pan to zone 2 in 3 @CHARACTER walks to spot 1.280 200 0 in zone 2 in 3 AND CHARACTER does it while run_jog
Hope it helps!
P.S You can write something like:
&pan to zone 2 in 3@YOU walks to spot 0.68 122 267 in zone 2 in 3 AND YOU does it while walk_neutral
Jadlyss
September 24, 2018, 11:09pm
5
When you look at the spot guide (usually the one you copy)
I didn’t use a spot guide…
Jadlyss
September 24, 2018, 11:10pm
7
Did you use your phone to spot the character?
JemU776
September 24, 2018, 11:11pm
9
0.68 is fine to write, I believe. The problem is that the follow command can’t be used with spot directing
Jadlyss
September 24, 2018, 11:11pm
10
Ok so when you spot a character, you can see down below that after the word spot It’s a 4 letter number sequence.
Thanks to both of you! I’ll try different things out. Thanks!
Jadlyss
September 24, 2018, 11:13pm
12
On your phone, it should be right near the bottom left, make sure to copy each and every digit!
JemU776
September 24, 2018, 11:13pm
13
No problem! Glad to help <3
And remember this:
The follow command does not work with spots. You will have to pan and make your character walk at the same time:
&pan to zone # in T@CHARACTER walks to spot % x y in zone # in T and CHARACTER does it while animation
Good luck!
