Preview error not seen before :/

I’ve never seen this message before whilst trying to preview what I’ve put. I’ll copy it now, if someone can explain what it means I’d be very grateful!!

Error: Cannot enlarge memory arrays. Either (1) compile with - s Total_MEMORY=X with X higher than the current value 268435456, (2) compile with s ALLOW_MEMORY_GROWTH=1 which allows increasing the size at runtime or (3) if you want malloc to return NULL (0) instead of this abort, compile with -s ABORT_MALLOC=0

2 Likes

Reload the page or close the window and open it again. :two_hearts:

1 Like

Cheers, error is sorted now :+1:
Got a new one now, it says there’s an error (on the bold line below) but I don’t know why it’s wrong :see_no_evil:

INT. BATHROOM MIRROR 2 with BATHROOM_MIRROR_2 with 80S
&cut to zone 1
&zoom on 320 512 to 137% in 0
&overlay BATHROOM_MIRROR_2 shifts to 0 0 in zone 1 AND overlay BATHROOM_MIRROR_2 scales to 1.000 1.000 in zone 1 AND overlay BATHROOM_MIRROR_2 moves to layer 2 AND overlay BATHROOM_MIRROR_2 opacity 0.5
&overlay 80S shifts to 63 90 in zone 1 AND overlay 80S scales to 1.000 1.000 in zone 1 AND overlay 80s moves to layer 3 AND overlay 80s opacity 1
@MC PIPPA changes into MC PIPPA_Pjs
@MC PIPPA spot 1.091 222 213 in zone 1 at layer 4 AND MC PIPPA faces right AND MC PIPPA is idle_loop AND MC MUM spot 1.280 218 47 in zone 1 at layer -1 AND MC MUM faces right AND MC MUM is idle_loop

Avoid using “&” “AND”
In same line
Instead use
&overlay 80S shifts to 63 90 in zone 1
&overlay 80S scales to 1.000 1.000 in zone 1
&overlay 80s moves to layer 3
&overlay 80s opacity 1

Just tried it, still saying it’s not a valid command for the layer and opacity lines :thinking:

use @ atleast once before starting ‘&’ command.

Episode is trial and error thing. You need to keep trying till it is error free :joy:

You forgot to capitalise the two s

1 Like